Characteristics:
- Load-bearing structure made of anti-corodal aluminum profile;
- Continuous base under the entire machine made of anti-corodal aluminum;
- Double-skinned steel sandwich panels with an inner galvanized steel sheet and an outer galvanized steel sheet coated with a scratch- and corrosion-resistant material;
- 46 mm thick insulated with polyurethane foam or mineral wool with directional cells;
- Aluminum-finned dampers with an aerodynamic profile with opposite ribs;
- Class F6 air supply and intake filters with rigid pockets (EN 779:2011);
- A vertically mounted cross-flow heat recovery unit (HRU) is designed to maximize efficiency in both summer and winter operation while reducing air-side load losses. The HRU includes a bypass damper for automatic free-cooling/free-heating control;
- The motor driving the heat recovery wheel with belt and pulley drive is equipped with a variable speed controller;
- Centrifugal fans with direct-connected brushless EC motors. They use ultra-efficient electronically commutated motors with permanent magnets, the speed of which is controlled by a built-in controller.
- Large inspection doors in the same design as the panel are equipped with safety locks and locking handles.
- Available for indoor and outdoor installation.
- Available as a single-piece unit or with individual sections.
ACCESSORIES:
- Cold water heater;
- Hot water heater;
- Steam humidifier or humidifier with steam pack;
- Silencers;
- G4 pre-filters.
Control and management functions:
- Heat recovery control in maximum economy mode with automatic free cooling control based on temperature or enthalpy and integrated anti-freeze control;
- Supply temperature compensation based on outside air temperature;
- Constant flow fan operation based on filter contamination;
- Variable flow fan operation with:
- - 0-10 V signal control (CO2 sensor or potentiometer) for single-zone use;
- - constant pressure control for multi-zone use;
- Time-based control of heating media using 2-way or 3-way valves, depending on the system;
- Weekly time interval management;
- BMS interface with Modbus or LON protocol;
- Monitoring via Web-Ethernet port using TCP/IP technology;
- GSM modem kit for remote monitoring via SMS with alarm devices.
Detailed information can be found on the manufacturer’s website at www.rhoss.com or contact our specialists.
